Xpress Flex® Tips & Tricks

Check lot codes and expiration dates located on the bottom of strip containers. These should match the selected options during the water test.

Shuttle should be empty and closed when XFConnect is started. If not, the Xpress Flex will need to be unplugged to reset.

When using the Iron and Phosphate prep reagents, add them into the respective chambers before adding sample water. This improves mixing.

When loading the strip clip, use only the strips for the tests you need for the water evaluation. This may just be Flex 3 strip.

Use the strip loader to make sure the strips are properly aligned.

Be sure to have audio available on your computer to hear audible cues.

Dip timing is important. Pay attention to the sounds and animation as instructed. Remove promptly. Avoid flinging water.

Begin test prep for the next water sample while the Xpress Flex is testing the current sample.

Always remove strips from Xpress Flex after testing.

Personalize your sureTREAT® profile by editing chosen tests and recommendations based on your objectives.

Graphics can be added to the header of your sureTREAT report when creating your profile.

Always ensure your software is up to date.